The Plunge Lab

Calculators

Cold Plunge and Sauna Running Cost Calculator

What a chiller or sauna heater adds to your electric bill: watts x hours x your rate, per day, month and year, with the working shown.

watts
hr

Nobody publishes duty cycles. 6-12 hours brackets a covered, insulated tub (low) through a harder-working setup (high).

¢/kWh

Default is the US residential average, 18.16¢ (EIA). Your bill prints your own rate per kWh.

Per month

$19.61

450 W × 8 hr ÷ 1,000 = 3.60 kWh a day; × 18.16¢ = $0.65 a day; × 30 days = $19.61.

Per year

$235

1314 kWh a year. A cover and insulation shorten compressor hours more than any other change, so they move this number most.

How is the running cost calculated?

Watts times hours, divided by 1,000, times your rate. That line is the whole bill, for a chiller or a sauna heater. The calculator starts at the US residential average of 18.16 cents per kWh from the EIA's Electric Power Monthly; replace it with the rate on your own bill, which can be half or double that.

Why chiller hours are a range, not a spec

A chiller draws its rated watts only while the compressor runs, and no manufacturer publishes how many hours a day that is. It depends on your cover, insulation, room temperature and set point. The cold plunge electricity guide computes across 6-12 compressor-hours a day and lists every published wattage the dropdown uses.

Why the sauna figure is a ceiling

The sauna side bills the heater at full rated draw for the whole heat-up and the whole session. Once the room reaches temperature a thermostat cycles the elements, so a real bill lands below the figure shown. We print the ceiling because heater makers do not publish a duty cycle. The full cost of owning one, purchase and electrician included, is in what a home sauna really costs.

Frequently asked

How much does a cold plunge cost to run per month?
About $12-29 a month for a 1/2 HP chiller at the US average rate of about 18 cents per kWh, across 6-12 compressor-hours a day. The formula is watts x hours / 1,000 x your rate per kWh.
How much does it cost to run a sauna?
Heater kW x hours x your rate. A 6 kW heater run for a 30 minute heat-up and a 20 minute session uses at most 5 kWh, about 91 cents at the 18.16 cent US average (EIA, August 2026). A 2 kW infrared cabin for 45 minutes uses 1.5 kWh, about 27 cents. The thermostat cycles the elements once the room is hot, so real use comes in under these ceilings.
Where do I find my electricity rate?
Your bill prints it as cents (or dollars) per kWh. Divide the energy charges by the kWh used if it only shows totals. The calculator defaults to the US residential average from the EIA's Electric Power Monthly.